G-Technology G-SPEED eS Guida di Installazione Scaricare il pdf (Pagina 7)

G-SPEED eS INSTALLATION GUIDE - Windows

8.2 Attaching G-SPEED eS to the G-TECH RAID Controller

1. Attach one end of the supplied eSATA cable to the eSATA

port located on the back of G-SPEED eS.

2. Attach the other end of the eSATA cable to Port 1 (port

closest to motherboard) on the G-Tech RAID controller as

shown below.

3. Attach the power cord to the back of G-SPEED eS and

connect the other end to AC power.

4. Power on G-SPEED eS.

8.3 Installing the G-Tech PCIe RAID Controller Software

There are three steps required to fully install the software

for the G-SPEED eS Controller.

1. Install the Windows driver

2. Update the Controller firmware

3. Installing the web GUI

Check for software updates at

http://www.g-technology.com/Support/

1. Install the G-SPEED eS Windows driver

a. Power on the workstation

b. Insert the G-Tech Product CD into the CD-ROM drive

When the CD loads a welcome screen may appear.

Close this window.

c. When the system boots the “Found New Hardware

Wizard” will appear. Select “Install from a list or specific

location” and click <Next>.

e 7

1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

Nessun commento

G-Technology G-SPEED eS Guida di Installazione Pagina 7